Build error for ARM compute for android

Question

0 个投票

I am trying to run the example code

I am getting the following error

But, I have already set the right path for ARM compute library. All my verifications are successful

What could be the reason for this?

0 个评论
显示 -2更早的评论隐藏 -2更早的评论

Answer 1

Sutanu Maiti 2021-11-20

1 个投票

Can you please have a look at the model's config set whether the ARM compute library version is set to 20.02.1?

To check that please follow below steps:

1. In the Configuration Parameters dialog box, select Code Generation from the left pane and from the Target selection section, set Language to C++ .

2. Select Code Generation > Interface and in the Deep learning section, set these parameters:

a. Set Target library to ARM Compute .

b. Select ARM Compute Library version based on the installation you chose in the Hardware Setup screen. This example uses the library version 19.05 .

c. Set ARM Compute Library architecture to armv7 .

3. Click Apply > OK.

Please build again if it was not set correctly and if fails again after setting correctly please contact technical support.