Build error for ARM compute for android
5 次查看(过去 30 天)
显示 更早的评论
I am trying to run the example code
I am getting the following error
But, I have already set the right path for ARM compute library. All my verifications are successful
What could be the reason for this?
0 个评论
采纳的回答
Sutanu Maiti
2021-11-20
Can you please have a look at the model's config set whether the ARM compute library version is set to 20.02.1?
To check that please follow below steps:
1. In the Configuration Parameters dialog box, select Code Generation from the left pane and from the Target selection section, set Language to C++ .
2. Select Code Generation > Interface and in the Deep learning section, set these parameters:
a. Set Target library to ARM Compute .
b. Select ARM Compute Library version based on the installation you chose in the Hardware Setup screen. This example uses the library version 19.05 .
c. Set ARM Compute Library architecture to armv7 .
3. Click Apply > OK.
Please build again if it was not set correctly and if fails again after setting correctly please contact technical support.
0 个评论
更多回答(0 个)
另请参阅
类别
在 Help Center 和 File Exchange 中查找有关 Android Devices 的更多信息
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!