Data type mismatch error in Simulink

SSK
2022 1 14
2 个回答
回答已采纳
更新时间：2022 1 20
23 次查看（30 天）

0 个投票

I am running a simulation of Direct Torque Control of Induction Motor in Simulink. Howeve in sector formation I'm getting the following error:
Data type mismatch. 'Input Port 1' of 'DTC_Trial1/Hystersisis Control and Pulse Generation /Subsystem/Sum1' expects a signal of data type 'boolean'. However, it is driven by a signal of data type 'double'.
I'm not able to understand why this is happening. Any help would be appreciated. Attached file for reference. Thank you.

请先登录，再回答此问题。

 采纳的回答

Pat Gipper
Pat Gipper 2022-1-17

0 个投票

I saw a number of other issues in this model.
1) I think the inverter needs a ground reference added on the emitters of the lower corner IGBTs. Once you do this then you will be able to measure the stator voltages and currents with the Three-Phase V-I Measurement block as needed.
2) The subsystem calculating the sector needs further work. Try using a mod(2*pi) instead of the boolean logic, as I believe you desire to wrap the result. Also it is outputting a sector value of zero, which I think is incorrect. Try adding 1 to the result.
3) The Stator voltage selector using a fnc block that is not compatible with the psi_s input. Should this be an absolute value function?

4 个评论
显示 2更早的评论 隐藏 2更早的评论

SSK
SSK 2022-1-19
Respected Sir,
Thank you for your reply. I did some of the changes you suggested. Adding the ground helped, however there seemed to be an issue with the inverter I used. Hence I replaced it with the block in Simulink. Atleast, now the switching pulses. Still after some time it all goes to zero. I am not able to rectify the problem. I have added the updated files. Any help is appreciated. Thank you again for your reply.
Pat Gipper
Pat Gipper 2022-1-19
I made some changes shown below in my attachment that seems to have fixed all the problems. Let me know how it works for you.
1) Voltage sensing (Vs_a,Vs_b,Vs_c) are now phase to ground versus phase to phase.
2) Changed the slip speed initial condition to 1 so the induction machine starts from 0 rpm.
3) Added a modulo function in the "Finding sector" matlab code.
4) Swapped the Is_beta and Is_alpha inputs to "Torque Estimation"
SSK
SSK 2022-1-20
Yes sir it's working a lot better now. Though there is some noise in the stator currents, the entire system is working as it was desired and the locus is also obtained. Thank you for the help.
Pat Gipper
Pat Gipper 2022-1-20
I'm glad to hear it. Switching noise in the stator currents is to be expected with this control scheme.

请先登录，再进行评论。

更多回答（1 个）

Fangjun Jiang
Fangjun Jiang 2022-1-14

0 个投票

  1. The easiest solution is to add a Data Type Conversion block.
  2. The proper solution is to set the proper data type at the relevant blocks.
  3. The related setting is the diagnostic for mismatch data types.

类别

在 帮助中心 和 File Exchange 中查找有关 Converters (High Power) 的更多信息

产品

版本

R2020b

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by