How to save image after encryption?
4 次查看(过去 30 天)
显示 更早的评论
I have code for encrypt an image, then ineed to save image after encryption to use it in another seperate code .
which command is prefere, imsave, imwrite? I try to use both but the saved image can't be showed correctly when i used imshow command.
回答(2 个)
Walter Roberson
2022-1-16
My suspicion would be that your original image is uint8 and that when you did the encryption, you did not make sure to create uint8 . Perhaps your results are all integers 0 to 255, but I suspect that class() of them is double() .
If your encrypted image is double() but only uses integers 0 to 255, then uint8() it.
If your encrypted image is double() but has some entries that are not integers 0 to 255, then you might have a problem.
2 个评论
Walter Roberson
2022-1-16
Either be more careful in doing the permutation to retain the original data type, or else take uint8() of the permutation.
Image Analyst
2022-1-16
Unless your encryption produced another uint8 or uint16 image, you're probably best just saving it as a binary file with a .bin or .dat extension since no standard program will be able to read it and decrypt it successfully if you save as a .PNG extension - it will just confuse them and they'll throw an error. Something like (untested):
fid = fopen('encryptedImage.bin', 'wb');
fprintf(fid, '%c', yourImage);
fclose(fid);
0 个评论
另请参阅
类别
在 Help Center 和 File Exchange 中查找有关 Encryption / Cryptography 的更多信息
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!