Changing HDL FIR filter numerator while simulation is running
1 次查看(过去 30 天)
显示 更早的评论
We are working on zynq 706 using MATLAB. we are using HDL optimized FIR filter in simulink and we are trying to change filters numenator . but each time we need to stop the simulation for cahnging numenator . How can we change the parameters while simulations contionue to run
0 个评论
回答(2 个)
Bharath Venkataraman
2022-1-18
编辑:Bharath Venkataraman
2022-1-18
You can set the property Coefficients Source to input port and feed the coefficients via the input port. This will allow you to change coefficients without having to stop the simulation.
Example on how to do this: https://www.mathworks.com/help/dsp/ug/optimizing-prog-fir-resources.html
0 个评论
muhammad ahmad
2022-1-31
2 个评论
Bharath Venkataraman
2022-1-31
I think it may be best for you to contact MathWorks support with your specific files to see if we can look further into the problem at hand.
另请参阅
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!