清空筛选条件
清空筛选条件

OBSERVING SIGNAL GENERATOR OUTPUT AT HIGH FREQUENCY IN SIMULINK

13 次查看（过去 30 天）
Amrutha
Amrutha 2014-11-18
回答： Orion 2014-11-18
Hi, In simulink,when i use signal generator at low frequency(egs:1 rad/sec) and observe the sine wave in a scope,my output is correct.But when the frequency is increased(egs:10 rasd/sec),the output is not correct.why is it so?Can somebody help me.

请先登录，再回答此问题。

采纳的回答

Orion
Orion 2014-11-18
Hi,
My guess is that you forget to change your simulation parameters.
In the toolbar :
Simulation -> Model Configuration Parameters.
change the solver to fixed-step, and put a small sample time to force Simulink to simulate at a desired rate.

更多回答（0 个）

类别

在 Help Center 和 File Exchange 中查找有关 Sources 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by