Hi Pratham,
As per my understanding, you are trying to use the in-built Simulink "Scrambler Block" to scramble the input binary code and want to get a scrambled output.
These high level steps will help you:
- Attach a "From Workspace" block to the input of "Scrambler Block".
- Attach a "To Workspace" block or a "Scope Block" to the output of "Scrambler Block" to visualize your output. Set the "Save format" block parameter of the "To Workspace" block to "array.
- Change the following block parameters of the "Scrambler Block":Calculation base = 2Set the "Scramble polynomial" and "Initial states".
- Assign a value to the "simin" variable from in the MATLAB workspace. This variable will be given as an input to the "Scrambler Block"Ex: >>simin = [1 0 1 0 1 1 1]
- Run the simulation, You could visualize the output in the "out.simout" variable
You may visit the following reference link to understand the Scrambler Block in detail:
I have attached a dummy Simulink model, named "scrambler_dummy.slx" for your reference.
Hope this helps.
Regards,
Ninad
