State Flow Error - occurs when trying to run

2011 9 21
1 个回答
回答已采纳
20 次查看（30 天）

0 个投票

Hello,
I am trying to get stateflow to run I get the model error from an unknown source reported by simulink "Error using ===> create_file_name info at 267 unexpected compiler".
How would I correct this error?

2 个评论
显示 无 隐藏 无

Kaustubha Govind
Kaustubha Govind 2011-9-22
Try running "mex -setup" and run the model again. Note that you need to have a supported compiler installed. Look at the list on the following page corresponding to your version and platform: http://www.mathworks.com/support/compilers/previous_releases.html
Fabian
Fabian 2013-1-24
Had the same problem
Thank you Kaustubha for the help

请先登录，再进行评论。

请先登录，再回答此问题。

 采纳的回答

Andreas Goser
Andreas Goser 2011-9-22

0 个投票

Along the lines of Kaustubha's comment. The most frequent failure mode is, that users do not know that
  1. Stateflow always needed a C Compiler, but the LCC Compiler came within a Win32 installation
  2. There is no C Compiler installed with Win64 MATLABs
  3. BUT: There is always a supported free of charge MSVC Express edition compiler
Also interesting: Preparing for 64 Bit

更多回答（0 个）

类别

在 帮助中心 和 File Exchange 中查找有关 Decision Logic 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by