How to extract Signal Parameters from an Eye Diagram
3 次查看(过去 30 天)
显示 更早的评论
Hello and Good day every one
I have this eye Diagram which I attached its code the data to run the code and plot the eye. I have this eye diagram:
Now I want to extract some vital information about the signal such as Cross over area in eye diagram (jitter), signal to noise ratio (Distortion), Bit error rate, Slope of the eye (Sensitivity), Eye height, width and amplitude and pretty much everything possible about the signal one can read from an eye diagram. I do not know how to manipulate my data to achieve these parameters.
The code:
load('eye2.mat')
hold on;
for k = 1:N_symb
u_idx = samp_per_symb*(k - 1) + rel_idx;
if (k == 1) || (k == N_symb)
u_idx = mod(u_idx - 1, N_samp) + 1;
end
plot(t_plot, real(u(:, u_idx)),'k');
end
ylabel('I channel')
grid on;
zoom on;
box on;
0 个评论
回答(0 个)
另请参阅
类别
在 Help Center 和 File Exchange 中查找有关 National Instruments Frame Grabbers 的更多信息
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!