Switching from Data Acquisition Sessions to Data Acquisition Objects in MATLAB introduces some changes in how things are handled, including setting properties like InitialCount for encoders. The behavior you're experiencing, where setting the InitialCount does not seem to affect the starting value of the encoder count, could be due to a few reasons. Let's explore some steps and considerations to troubleshoot and potentially resolve this issue:
1. Verify Property Support
First, ensure that the InitialCount property is supported and behaves as expected with the Data Acquisition Object (daq) interface for your specific hardware. The support and behavior might vary between different versions of MATLAB and hardware devices.
- Documentation Check: Refer to the latest MATLAB documentation for your version to confirm that InitialCount is a supported property for encoders with the Data Acquisition Object interface for your specific NI device.
- Compatibility: Ensure your hardware and its drivers are fully compatible with the version of MATLAB you're using. Sometimes, newer features or changes in behavior can be related to driver or firmware updates.
2. Correct Property Setting
Ensure the property is set correctly in your code. Your pseudocode seems correct, but it's always good to double-check for typos or incorrect object references. Also, ensure that the property setting is not being overwritten or reset somewhere else in your code before the acquisition starts.
3. Property Application Timing
With the Data Acquisition Object interface, the timing of when properties are set can sometimes matter more than with the session-based interface. Ensure the InitialCount is set after adding the channel and configuring the encoder type but before starting the acquisition.
4. Test with a Simplified Setup
Try simplifying your setup to isolate the issue. Use a minimal script that only creates the Data Acquisition Object, adds one encoder input channel, sets the EncoderType and InitialCount, and then immediately reads the encoder value. This can help determine if the issue is with the property itself or how it's being used in the context of your larger application.
Here's a slightly revised version of your pseudocode with explicit steps:
% Create Data Acquisition Object
dq = daq("ni");
% Add encoder input channel
ch = addinput(dq, 'Dev2', 'ctr3', 'Position');
% Set Encoder Type (assuming 'app.instrument.Inputs.TerminalConfig{ii}' is valid)
ch.EncoderType = 'X4'; % Example, replace 'X4' with your specific encoder type
% Set Initial Count
ch.InitialCount = 2^30;
% Start background acquisition to test (simplified example)
start(dq, "Duration", seconds(10)); % Adjust duration as needed
% Read and display the initial value (after some delay to ensure acquisition has started)
pause(1); % Short pause to ensure acquisition starts
[data, timestamps] = read(dq, seconds(1), "OutputFormat", "Matrix");
disp(data(1));
