清空筛选条件
清空筛选条件

ROS Simulink algebraic loop

29 次查看（过去 30 天）
Tristan Sinnecker
评论： Muhammad Saad 2024-7-10
Dear all,
I am tryining to build up a HIL environment by using ROS in Simulink. If I try to run a simulation, I get the following error:
"Algebraic loops are not supported in generated code. Use the 'ashow' command in the Simulink Debugger to see the algebraic loops. If algebraic loops only exist during code generation, please check if configset parameter 'CombineOutputUpdateFcns' is on, set it off might resolve algebraic loops."
Is there a ways to turn off 'CombineOutputUpdateFcns' in Simulink? Trying to do so in the Configuration Parameters is not possible, since this setting is blocked (see figure).
Thank you very much for your help!

请先登录，再回答此问题。

回答（1 个）

stozaki
stozaki 2022-3-4
see Dependencies section.
Single output/update function

类别

在 Help Center 和 File Exchange 中查找有关 Publishers and Subscribers 的更多信息

标签

产品


版本

R2021b

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by