清空筛选条件
清空筛选条件

Using shared configurations with configured hardware board

17 次查看（过去 30 天）
KristianT
KristianT 2022-3-7
回答： Divya 2024-1-22
Hi,
I'm using a shared configuration as described here: https://www.mathworks.com/help/simulink/ug/referencing-configuration-sets.html
This seems to work fine until I set Hardware Implementation > Hardware board to "Raspberry PI". When I do this I get the following error when opening a model using the shared configuration :
------------
Parameter update is not supported for a configuration reference. Update parameter in the configuration set that it references.
Component:Simulink | Category:Model error
-----------------
And then I do not get hte Hardware tab I usually get when not using shared configurations.
Does anyone know why this isn't working?
Thanks in advance!
  1 个评论
Hangxu Li
Hangxu Li 2023-9-25
I also have the same problem when using 21a. But it works for 23a now. Did you find any solution to this problem?

请先登录，再进行评论。

请先登录，再回答此问题。

回答（2 个）

Nakul Khadilkar
Nakul Khadilkar 2022-3-11
Hi Kristian,
Try setting the configuration parameter as below:
configurationSettings.set_param('Name', 'value');
‘configurationSettings’ should be a variable in your workspace and the variable’s name should match Referenced configuration set name in the Model Explorer.
-Nakul
Divya
Divya 2024-1-22
Hi,
need to take referenced Configuration object that model config references,and then set required parameter.
configSet = getActiveConfigSet(modelName);
referencedConfigObj = getRefConfigSet(configSet); % taking referenced Configuration object
set_param(referencedConfigObj, 'parameter_name', 'value');

类别

在 Help Center 和 File Exchange 中查找有关 Run on Target Hardware 的更多信息

标签

产品


版本

R2021b

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by