Batch mode between Matlab and Hypermesh

26 次查看（过去 30 天）
Adeline War
Adeline War 2022-3-9
回答： Dinesh 2023-12-29
Please tell me a step-wise process of how to create batch mode between Matlab and Hypermesh. If possible with codes in it?
  3 个评论
显示 1更早的评论
Adeline War
Adeline War 2022-4-8
Hi Eric, what if my solver is optistruct. Can I use the same line?
Adeline War
Adeline War 2022-4-11
@Eric Trudel By script, do you mean the command.tcl file generated after creation of model?

请先登录，再进行评论。

请先登录，再回答此问题。

回答（1 个）

Dinesh
Dinesh 2023-12-29
Hi Adeline,
To create a batch mode interaction between MATLAB and HyperMesh, you can use MATLAB's system commands to call Hypermesh scripts. Start by writing a HyperMesh script (.tcl or .hm script) for the operations you need. Then, from MATLAB, use the "system" command to execute HyperMesh with the script as an argument. Ensure that both MATLAB and HyperMesh are properly installed and configured to run from the command line.
The following is the command that you can use in your MATLAB command line:
system('hypermesh -tcl yourscript.tcl')
The following is an example of a tcl script that you would write:
# Start Hypermesh in batch
# Load a model file
*openmodel "path/to/your/model.hm"
# Execute any operations of your choice here
# Save model here
*feoutput "OptiStruct" "path/to/your/output/file.fem" 0 0 1 1

类别

在 Help Center 和 File Exchange 中查找有关 Introduction to Installation and Licensing 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by