How to draw a pulse train

32 次查看（过去 30 天）
Sadiq Akbar
Sadiq Akbar 2022-3-15
评论： Scott MacKenzie 2022-3-17
I want to draw a pulse train in Matlab like the one shown blue in attached picture. The duration of each pulse is Tp and there are M=199 zeros in between two consective pulses. The PRI of the pulse train is 200Tp. Then I want to decompose each pulse into 7 small pulses of amplitude +1 and -1 (i.e., 1Tp=7Tc where Tc=28ns is the duration of small pulse) like shown white in the attached picture.
  1 个评论
Sadiq Akbar
Sadiq Akbar 2022-3-16
I write a code that draws a square train. The code is as below:
clear all
clc
fy=100;
wy=2*pi*fy;
duy=0.02;
fs=20000;
dt=1/fs;
t=-(duy-dt):dt:(duy-dt);
A=1.5;
y=A*square(wy*t);
plot(t,y,'k')
axis([-duy duy -2.5 2.5])
xlabel('Seconds')
title('Square signal')
Now I want to replace each -ve pulse with M=199 zeros. Can anyboy help me how to do that?

请先登录，再进行评论。

请先登录，再回答此问题。

回答（1 个）

Scott MacKenzie
Scott MacKenzie 2022-3-16
编辑：Scott MacKenzie 2022-3-17
Ran in:
It seems you want to replace the negative portion of the pulse with zeros. Like this, perhaps:
fy=100;
wy=2*pi*fy;
duy=0.02;
fs=20000;
dt=1/fs;
t=-(duy-dt):dt:(duy-dt);
A=1.5;
y=A*square(wy*t);
subplot(1,2,1);
plot(t,y,'k')
axis([-duy duy -2.5 2.5])
xlabel('Seconds')
title('Square signal')
subplot(1,2,2);
y(y<0)=0;
plot(t,y,'k')
axis([-duy duy -2.5 2.5])
xlabel('Seconds')
title('Square signal')
  6 个评论
显示 4更早的评论
Sadiq Akbar
Sadiq Akbar 2022-3-17
ok Scott MacKenzie thank you very much. At least you tried your best to help me out. So thank you very much for your try and your good step for my help.
Scott MacKenzie
Scott MacKenzie 2022-3-17
You're welcome. Good luck.

请先登录，再进行评论。

类别

在 Help Center 和 File Exchange 中查找有关 Pulse and Transition Metrics 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by