How can I load a preferences view (with Simulink.sdi.loadView) in simuation data inspector only with .mat file ?

Question

YK_Valid 2022-3-18

0
链接

此问题的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/1674949-how-can-i-load-a-preferences-view-with-simulink-sdi-loadview-in-simuation-data-inspector-only-with

评论： YK_Valid 2023-2-2

Hi community,

I am trying to load .mat files for debug using Simulation Data Inspector, and sometimes I need to check the same signals for differents .mat files, For that I found a way that may help me, which is Simulink.sdi.loadView('savedView.mldatx'), but its dones not work as expected for me (using Matlab 2020b).

here's a steps:

1-In a folder a have a .mat file, and I put the main matlab path in that folder Path.

in Command windows put the below commands

2-Simulink.sdi.view

3-runID = Simulink.sdi.createRun('Name of mat file','file','file.mat');

after having the .mat loaded, I can setup my signals preferences and plot layout, then I save it with:

4-Simulink.sdi.saveView('saveAview') %here I save the view that I need to load each time

Now the steps to load the saved preferences.

5-Simulink.sdi.clear

6-runID = Simulink.sdi.createRun('Name of mat file','file','file.mat'); %load again my .mat file

4-Simulink.sdi.loadView('savedView.mldatx'); %load my saved preferences.

But it only loading the plot layout dimension (ie, 3x3) and not the signals within the plots.

can you please help if you have the same problem doing the same steps ?

Thanks in advance for your help

0 个评论
显示 -2更早的评论隐藏 -2更早的评论

请先登录，再进行评论。

请先登录，再回答此问题。

Answer 1

Sarah Blagdon 2022-10-19

0
链接

此回答的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/1674949-how-can-i-load-a-preferences-view-with-simulink-sdi-loadview-in-simuation-data-inspector-only-with#answer_1079218

编辑：Sarah Blagdon 2022-10-19

在 MATLAB Online 中打开

I think the problem is that the name of the saved view doesn't match the name of the view you are loading. What happens if you use Simulink.sdi.loadView('saveAview.mldatx') instead? Here's a little code template similar to yours that worked for me:

Simulink.sdi.view 
runID1 = Simulink.sdi.createRun('run1','file','file1.mat');
Simulink.sdi.saveView('saveAview') 
Simulink.sdi.clear
runID2 = Simulink.sdi.createRun('run2','file','file2.mat');
Simulink.sdi.loadView('saveAview.mldatx');