清空筛选条件
清空筛选条件

How to change a parameter while the signal is running?

1 次查看（过去 30 天）
Ali Albaidhani
Ali Albaidhani 2022-4-4
Hello everyone,
I want to generate a signal that can be changed while running. I want to be able to change the magnitude while the signal is running. I tried generating a signal in background and i wrote different values for the magnitude in the command box but it didn't change anything.
I have the following code:-
%-------------------------------------
clearvars
clc
d = daqlist("ni");
deviceInfo = d{1, "DeviceInfo"};
dq = daq("ni");
fidData = fopen("logData.bin","w");
fidTime = fopen("logTime.bin","w");
DisplayTime=1;
s = daq.createSession('ni');
s.Rate=5000;
addAnalogInputChannel(s,'Dev2','ai11','Voltage');
lh = addlistener(s,'DataAvailable',@plotData);
lh1 = addlistener(s,'DataAvailable',@(src, event)logData(src, event, fidData,fidTime));
s.IsContinuous=true;
s.NotifyWhenDataAvailableExceeds=floor(DisplayTime*s.Rate);
%Output
addAnalogOutputChannel(s,'Dev2','ao0','Voltage');
Fs=s.Rate
t1=100;
t = 0 :1/Fs : t1-1/Fs;
A=0.5;
data0 = A*sin(2*pi*t*159.2)';
b=repmat(data0,5,1);
queueOutputData(s,b);
datagiver = addlistener(s, 'DataRequired',@(src,event)...
src.queueOutputData(b));
figure(1)
clf
startBackground(s);
%%
s.stop
fclose(fidData);
fclose(fidTime);
%-------------------------------------
Please help if you have an idea. I need to do this because im making a controller for the magnitude value.
Regards
Ali

请先登录，再回答此问题。

回答（0 个）

类别

在 Help Center 和 File Exchange 中查找有关 Data Acquisition Toolbox Supported Hardware 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by