Simulink - PID Controller Tuning - Strange graphs

13 次查看（过去 30 天）
Milan Hrstka
Milan Hrstka 2022-4-9
评论： Sam Chak 2022-4-9
Hello, I'm trying to tune PID controller in Simulink (system with delay). My "model" in Simulink looks like this:
I used Cohen-Coon method to find parameters of PID controller. Input parameters for PID controller are all right but when i start the simulation I keep getting these "not smooth" graphs (via picture) and I don't know why. I already tried to change model settings -> solver -> min and max step size but there is no difference.
I would be grateful for any help with this problem.
  3 个评论
显示 1更早的评论

请先登录，再进行评论。

请先登录，再回答此问题。

采纳的回答

Sam Chak
Sam Chak 2022-4-9
Hi @Milan Hrstka
The spikes in the your original output signal was caused by the derivative filter in the PID controller block. More accurately, it's because you tuned the PID control gains manually using the Cohen-Coon method and directly inserted these 3 values into the block, without taking the effect of the derivative filter (N = 100 by default) into account.
There are generally two approaches to handle this situation:
  1. Tune the filter coefficient until you obtain a desired smooth output.
  2. Use the Ideal PID controller instead.
  2 个评论
Milan Hrstka
Milan Hrstka 2022-4-9
@Sam Chak
Thank you very much for your time, i appreciate it.
I tried to create the same model that you did (the ideal PID controller) and my results are not same to yours. I don't know where might be the problem.
Milan Hrstka
Milan Hrstka 2022-4-9
@Sam Chak
I think i just figured it out. I had bad value in step block by mistake.
Thanks very much!

请先登录，再进行评论。

更多回答（1 个）

Sam Chak
Sam Chak 2022-4-9
编辑：Sam Chak 2022-4-9
This is strange.
I only set the max step size = 1e-3 in the solver config paramaters to produce a smoother output signal. The rest of the settings remain unchanged.
Can you check the each value in the control gain block?
P = 0.8958
I = 0.210930325
D = 0.6073524
  2 个评论
Milan Hrstka
Milan Hrstka 2022-4-9
It was probably because of Step time value in Step block (it was 1 and I changed it to 0). Now it seems to be smooth.

请先登录，再进行评论。

类别

在 Help Center 和 File Exchange 中查找有关 PID Controller Tuning 的更多信息

标签

产品


版本

R2022a

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by