Fill in boundaries in Image

2 次查看（过去 30 天）
Jason
Jason 2015-1-15
评论： Image Analyst 2015-9-25
How can I fill in the red regions in the image below given by:
%DrawRegions from Binary onto raw image:
labeledImage = bwlabel(Back, 8); % Label each blob so we can make measurements of it
blobMeasurements = regionprops(labeledImage, ROI, 'all'); %ROI is original image
numberOfBlobs = size(blobMeasurements, 1);
hold on;
boundaries = bwboundaries(Back);
numberOfBoundaries = size(boundaries);
subplot(4,5,[1,2,6,7])
hold on
for k = 1 : numberOfBoundaries
thisBoundary = boundaries{k};
plot(thisBoundary(:,2), thisBoundary(:,1), 'r.', 'LineWidth', 1);
end
hold off;
i.e. the red boundaries in the image.
  4 个评论
显示 2更早的评论
Pete sherer
Pete sherer 2015-9-25
any solutions to this? I am trying to do the same
Image Analyst
Image Analyst 2015-9-25
Mohammad's code worked for Jason. Doesn't it work for you? If not, post your image and code in a new question.

请先登录，再进行评论。

请先登录，再回答此问题。

采纳的回答

Mohammad Abouali
Mohammad Abouali 2015-1-15
编辑：Mohammad Abouali 2015-1-15
Ok, but the red lines is pretty much the boundary of the regions in the binary image stored in the variable called back, right?
If that is the case, and assuming your raw-image is a one layer gray scale image, i.e. size of raw_image is NxMx1 (based on your past posts then 101x101) then here is what you should do
RGB(:,:,1)=min(double(Back)+double(raw_image)./max(double(raw_image(:))),1);
RGB(:,:,2)=double(raw_image)./max(double(raw_image(:)));
RGB(:,:,3)=double(raw_image)./max(double(raw_image(:)));
Of course Back needs to be the same size as of raw_image.

更多回答（0 个）

类别

在 Help Center 和 File Exchange 中查找有关 Computer Vision with Simulink 的更多信息

标签

产品

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by