How to make input in degree value with dwell time ?

this is a fairly complicated question depending how far you have to take it. If you want to create a Simulink model that is just a value that is 0, then goes to 270, and then back to 0 after 8 seconds, you can use a source block to create that.

https://www.mathworks.com/help/simulink/slref/pulsegenerator.html

To do it more complicated would require using some sort of timer. An integrator with an input value of 1 is an easy to implement a timer in Simulink. When it's output is 8, 8 seconds have passed. You can also reset the integrator once your reached the relevant time. However, if you need to make an actual motor move, you have to then translate that command to actual motor commands, which is very dependent on what type of motor you are using.

https://www.mathworks.com/learn/tutorials/simulink-onramp.html

https://www.mathworks.com/help/physmod/sps/ug/bldc-position-control.html

Regards,

Joel

1 个评论
显示 -1更早的评论隐藏 -1更早的评论

KRISHAN THILAKARATHNE 2022-5-19

Thanks Joel for your answer,

Actually this is question taken from assignment, it ask to use step input to make that input. I made step time=8 second, start value=0, final value=270, sample time=0 in side the paramenters of step input. Suppose it ok or do you have any other proposal ?

请先登录，再进行评论。