How to switch uitab using commands?

Question

Albert Bing 2022-5-11

0
链接

此问题的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/1716725-how-to-switch-uitab-using-commands

评论： Albert Bing 2022-5-11

I wrote a GUI program and needed to switch uitabs. Is it possible to switch to next uitab using command? Suppose I had 2 axeses, ax1 & ax2, axis(ax2) would switch to ax2, so how to switch uitab using commands?

If not possible, how to send a shortkey in MATLAB? If I can send a shortkey "ctrl+tab" using a command, it will do the uitab switching job.

P.S. the program uses figure, not uifigure.

0 个评论
显示 -2更早的评论隐藏 -2更早的评论

请先登录，再进行评论。

请先登录，再回答此问题。

Answer 1

cr 2022-5-11

0
链接

此回答的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/1716725-how-to-switch-uitab-using-commands#answer_961925

编辑：cr 2022-5-11

在 MATLAB Online 中打开

Use SelectedTab property of uitabgroup.

E.g.

f = figure;
tabgp = uitabgroup(f,'Position',[.05 .05 .3 .8]);
tabA = uitab(tabgp,'Title','Tab A');
tabB = uitab(tabgp,'Title','Tab B');
tabgp.SelectedTab = tabA; % Switch to tab A
tabgp.SelectedTab = tabB; % Switch to tab B