How to switch uitab using commands?

16 次查看（过去 30 天）
Albert Bing
Albert Bing 2022-5-11
评论： Albert Bing 2022-5-11
I wrote a GUI program and needed to switch uitabs. Is it possible to switch to next uitab using command? Suppose I had 2 axeses, ax1 & ax2, axis(ax2) would switch to ax2, so how to switch uitab using commands?
If not possible, how to send a shortkey in MATLAB? If I can send a shortkey "ctrl+tab" using a command, it will do the uitab switching job.
P.S. the program uses figure, not uifigure.

请先登录，再回答此问题。

采纳的回答

cr
cr 2022-5-11
编辑：cr 2022-5-11
Use SelectedTab property of uitabgroup.
E.g.
f = figure;
tabgp = uitabgroup(f,'Position',[.05 .05 .3 .8]);
tabA = uitab(tabgp,'Title','Tab A');
tabB = uitab(tabgp,'Title','Tab B');
tabgp.SelectedTab = tabA; % Switch to tab A
tabgp.SelectedTab = tabB; % Switch to tab B
Regards
  1 个评论
Albert Bing
Albert Bing 2022-5-11
Ah, it's a property of uitabgroup, a litttle like the case in uibuttongroup.

请先登录，再进行评论。

更多回答（0 个）

类别

在 Help Center 和 File Exchange 中查找有关 Migrate GUIDE Apps 的更多信息

标签

产品

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by