Modelling a voltage controlled current source
8 次查看(过去 30 天)
显示 更早的评论
Hi!
I have a school project, where i need to simulate the blindig of protecion and sympathetic tripping defense problems. I'd like to model a current source that responds to the voltage drop caused by a fault. I'm using the controlled current source block for it. The constant block has the effective power value which gets divided by the rms value of the voltage so it should give me the current. My problem is that when i connect this block to my circuit it doesnt do anything. I'd like to ask what is the problem with my model?
回答(1 个)
Joel Van Sickel
2022-6-13
This looks like it creates an algebraic loop. It's easier to do this type of modelling using simcape: https://www.mathworks.com/learn/tutorials/circuit-simulation-onramp.html
and use this block to model a dynamic load: https://www.mathworks.com/help/physmod/sps/ref/dynamicload.html
Regards,
Joel
0 个评论
另请参阅
类别
在 Help Center 和 File Exchange 中查找有关 Electrical Sensors 的更多信息
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!