Hi,
This is regarding the Simulink compile/build toolchain targeting ADALM Pluto SDR. The Pluto board is Rev C.
We are trying to generate an ELF file for an RF detector from a Simulink model and it looks like there is an issue in terms of the Pluto Receiver Object.
The error message is given below
### Starting build procedure for: DDK_pluto03may ### Generating code and artifacts to 'Model specific' folder structure ### Generating code into build folder: C:\Users\maddi\Documents\MATLAB\Pluto\Drone\DDK_pluto03may_ert_rtw ### Build procedure for DDK_pluto03may aborted due to an error.
Build Summary
Top model targets built: Model Action Rebuild Reason ========================================================================== DDK_pluto03may Failed Code generation information file does not exist. 0 of 1 models built (0 models already up to date) Build duration: 0h 0m 14.487s
The 'comm.SDRRxPluto' class does not support code generation. The error occurred for MATLAB System block 'DDK_pluto03may/ADALM-Pluto Radio Receiver'.
Caused by: May be caused by unspecified input dimensions, which cause Simulink to assign default input port dimensions. This issue can happen when an input port is in a loop, is driven by a Ground block or a source with unspecified dimensions, or has unconnected signal lines. Consider adding a Signal Specification block with specified dimensions in front of the input port.
Component:Simulink | Category:Block diagram error
I have tried adding a Signal Specification block. Did not seem to work. Not sure whether I did the block configuration correctly.
I hope to receive some suggestions from the forum.
Thanks in advance,
Manoj
