visadev cannot close connection

4 次查看（过去 30 天）
Yue Xiao
Yue Xiao 2022-5-25
编辑： chrisw23 2023-3-2
I use visadev to connect instrument through LAN. It can connect and send commands, no problems. But when I want to disconnect the instrument, sometimes MATLAB just shows busy. It will take very long time to disconnect. Sometimes I have to close MATLAB. Does anyone have the same issue, or any suggestions? Thanks.
Below it shows when I close the connection, it calls Channel.m and line 177 takes 9 minutes.
  2 个评论
Akshayaa Pandiyan
Akshayaa Pandiyan 2023-3-1
How do you disconnect the instrument?
chrisw23
chrisw23 2023-3-2
编辑：chrisw23 2023-3-2
I recommend to install the vendor specific VISA tools (typically niMax or Keysight ConnectionExpert) and use the IOTrace Tool to monitor communication, when trying to close the instruments session. Probably there's Matlab polling (loop functionality) active and it takes a long time to get the slot to execute your close cmd.
Another point maybe that there are multiple unclosed (older) session objects from debug runs that cause sooner or later communication blocks until Matlab was restarted. So be sure to clear up your object references when debugging will be stopped.
Unfortunately the code provided is not suited to analyze the problem deeper.

请先登录，再进行评论。

请先登录，再回答此问题。

回答（0 个）

类别

在 Help Center 和 File Exchange 中查找有关 Instrument Connection and Communication 的更多信息

标签

产品


版本

R2021a

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by