Dear esteem researchers, please I need help on how to simulate wind gust disturbance effect on quad-copter using simulink...?

8 次查看（过去 30 天）
UASLAB
UASLAB 2022-5-26
评论： UASLAB 2022-5-30
I want to simulate this wind model 𝜔 ̅(𝑡)= 𝛼_𝑖+𝛽_𝑖 sin⁡(𝑛𝑡) ,using simulink, as external disturbance input into the space model towards building a controller.

请先登录，再回答此问题。

采纳的回答

Sam Chak
Sam Chak 2022-5-26
Hi @ALABA PHILIP OPAYEMI
I think this is how you connect the Sine Wave block (external disturbance) to the Quadcopter system (State-space block).
with the parameters of entered in the Sine Wave block:
  3 个评论
显示 1更早的评论
Sam Chak
Sam Chak 2022-5-26
Hi @ALABA PHILIP OPAYEMI
I can answer Q1, but Q2 sounds like a physics question. Anyhow, look the following comparison.
To specify the time you want to wind gust to occur, you need to use an External Signal to trigger it. And that signal is a Ramp. So, connect a Ramp block to the Sine Wave block.
If you want to trigger the Wind Gust after 5 sec from the beginning of the simulation time, then set Start time: 5 sec.
Results:
Regarding the physics question, I think physicists can answer this better. Since you ask how to convert wind gust into wind force (load), I guess the wind gust is measured in wind speed. I think the formula is given by
where
is force of the wind gust acting on the quadcopter,
is the projected area of the quadcopter surface where the wind molecules are hitting,
is the wind pressure in SI units with is the speed of the wind gust,
is the drag coefficient for the quadcopter that is usually determined experimentally in the Wind Tunnel.

请先登录，再进行评论。

更多回答（0 个）

类别

在 Help Center 和 File Exchange 中查找有关 General Applications 的更多信息

标签

产品


版本

R2022a

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by