I want to connect my Arduino to App Designer by using the "drop down" list. This is what my app looks like:
First, I am looking for if there is any serial com. system. And I am writing them to Drop Down.
p = instrhwinfo('serial');
app.SerialPortsDropDown.Items = p.AvailableSerialPorts;
After this I have planned to read the serial port that is shown in the Drop Down and write it to serialport()
app.a = serialport(app.SerialPortsDropDown.value,9600);
Unfortunately these lines did not work. The error message I got:
Error using serialport (line 116) Unable to connect to the serialport device at port 'COM9'. Verify that a device is connected to the port, the port is not in use, and all serialport input arguments and parameter values are supported by the device.
So, the first two lines of code work. I am able to see COM9 (the com my arduino connected) in the drop-down list. This shows there is a serial port at COM9. But when it comes to reading it with app.a = serialport(app.SerialPortsDropDown.value,9600); it gives error.
How can I connect a serial port via the MATLAB App-designer?