STM32 Nucleo Board and MATLAB serial communication.

25 次查看（过去 30 天）
mcan06
mcan06 2022-5-30
回答： Abhinav Aravindan 2024-11-12，6:16
When I'm reading data from serial port on STM32 Nucleo Board in MATLAB, I got the following warning and I couldn't read data.
Code:
s = serialport('COM6', 460800)
flush(s);
data = readline(s);
Warning: The specified amount of data was not returned within the Timeout period for 'readline'. 'serialport' unable to read any data.

请先登录，再回答此问题。

回答（1 个）

Abhinav Aravindan
Abhinav Aravindan 2024-11-12，6:16
Hi @mcan06,
The Warning you are facing may be due to one of following reasons:
  1. An invalid command was sent to the device, so there is a problem reading the response to the command.
  2. Your device is connected to an incorrect serial port.
  3. An incorrect write terminator was sent to the instrument before attempting to read data, so there is no data to read.
  4. Your device is not configured to send data on the serial port.
You may refer to the following documentation for the troubleshooting steps:
https://www.mathworks.com/help/instrument/serial-port-warning-unable-to-read-any-data.html
A similar query related to using the STM32 Nucleo Board with “serialport” has been answered here for your reference:
https://www.mathworks.com/matlabcentral/answers/1972209

类别

在 Help Center 和 File Exchange 中查找有关 Serial Port Interface 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by