TMDSCNCD28335: How to use External Mode is not running in SImulink

1 次查看（过去 30 天）
SHIBU KUMAR
SHIBU KUMAR 2022-6-2
回答： Muskan 2024-1-22
does anybody have used TI TMDSCNCD28355 control card successfully in external mode using simulink, then let me what is the procedure because i am getting following error while connecting it using simulink
https://in.mathworks.com/matlabcentral/answers/1732385-simulink-external-mode-not-working-on-texas-instruments-f28335-control-card

请先登录，再回答此问题。

回答（1 个）

Muskan
Muskan 2024-1-22
Hi Shibu,
The error message mentioned by you indicates that communication was interrupted between the host and target, or that communication was never started at all.
There are a number of possible causes. Please confirm the switch/jumper settings being used on the device, if applicable. These should match the settings spelled out in the TI User Guide for the device, and on the Set up Serial Communication documentation page linked below.
https://in.mathworks.com/help/ti-c2000/ug/set-up-the-hardware-target.html

类别

在 Help Center 和 File Exchange 中查找有关 Simulink 的更多信息

标签

产品


版本

R2021b

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by