TMDSCNCD28335: How to use External Mode is not running in SImulink
2 次查看(过去 30 天)
显示 更早的评论
does anybody have used TI TMDSCNCD28355 control card successfully in external mode using simulink, then let me what is the procedure because i am getting following error while connecting it using simulink
https://in.mathworks.com/matlabcentral/answers/1732385-simulink-external-mode-not-working-on-texas-instruments-f28335-control-card
0 个评论
回答(1 个)
Muskan
2024-1-22
Hi Shibu,
The error message mentioned by you indicates that communication was interrupted between the host and target, or that communication was never started at all.
There are a number of possible causes. Please confirm the switch/jumper settings being used on the device, if applicable. These should match the settings spelled out in the TI User Guide for the device, and on the Set up Serial Communication documentation page linked below.
0 个评论
另请参阅
类别
在 Help Center 和 File Exchange 中查找有关 Simulink Functions 的更多信息
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!