XDS100 Embedded coder support error

Question

0 个投票

I am using F28379D to simulate LED blinking example using embedded coder support error.

I think I chose right hardware board and set target hardware resourses correctly.

But I get the error message as below.

I checked the device manager and saw that the new version of XDS100v3 is detected correctly as below

Anyone know what the problem is?

Thank you in advance.

0 个评论
显示 -2更早的评论隐藏 -2更早的评论

Answer 1

Vignesh 2023-10-9

0 个投票

Hello 종석 김,

I see that you are encountering errors while running LED blink example and you are working on F28379D.

I suggest you try the below steps as a workaround and check if is working at your end:

Work from Code Compiler Studio to make a connection to the target.
Then use the '.ccxml' from the Code Compiler Studio in MATLAB and try to establish the connection.
After downloading the code successfully, connect the serial port from debugger to 'SCI_A Rx' and 'Tx' pins on board from external mode.

I hope this answer helps you overcome the error you are facing.