How to simulate a DAB open loop in Simscape?

9 次查看（过去 30 天）
Prashant Mishra
Prashant Mishra 2022-7-21
回答： Sabin 2022-12-15
I am trying to simulate a DAB converter in simscape so that I can run linear analysis on it. I'm learning to use this linear analysis tool for control system design. I have not really used simscape before and am finding a bit difficulty using the solver blocks. For this current model, I am trying to simulate the model shown in picture 1.
Picture 1
It only simulates if i have a ground(electrical reference block) connected on each side of the transformer. If not, I get an error as shwon in picture 2.
Picture 2
When I put ground on both sides, I get 0 as my output. So, can someone help me find the mistake I'm doing here? Any suggestion/comment will definetely of good help.
Thank you!

请先登录，再回答此问题。

回答（1 个）

Sabin
Sabin 2022-12-15
Hi,
An electrical reference is required each side of the transformer. The output 0 might be related to the way you define gate signals, or the parameterization of the components used in the model. I suggest looking at the following example in Simscape electrical:
https://www.mathworks.com/help/sps/ug/dual-active-bridge-control.html
I hope this helps.

类别

在 Help Center 和 File Exchange 中查找有关 Electrical Sensors 的更多信息

标签

产品


版本

R2021b

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by