using plotResponse with ELANG

2015 2 10
1 个回答
更新时间：2015 2 11
3 次查看（30 天）

0 个投票

Hi All, I am trying to use plotResponse with ELANG.
the command I used is plotResponse(H,X,30), I can get the command working with plotResonse(H,X)
The documentation says This syntax is available when the ElevationAngleSource property is 'Input port'.
What does that mean ? I have tried plotResponse(H,X,'ElevationAngleSource','Input port', 30)
that does not work?
I have also tried plotResponse(H,X,'ELANG',30)
Any feedback is appreciated.
Regards, Philip

请先登录，再回答此问题。

回答（1 个）

Honglei Chen
Honglei Chen 2015-2-11

0 个投票

Hi Philip,
You need to set
H.ElevationAngleSource = 'Input port'
and then run
plotResponse(H,X,30)
HTH

2 个评论
显示 无 隐藏 无

Philip
Philip 2015-2-11
Hi Honglei, the above did not work, the script is:
H.ElevationAngleSource = 'Input port';
plotResponse(hrdresp,xr,30);
axis([-v_max v_max 0 range_max])
the error returned is
Error using sigutils.pvparse (line 23)
Each parameter specified must have a corresponding value.
Error in phased.RangeDopplerResponse/plotResponse (line 513) sigutils.pvparse(varargin{:});
Error in FMCWMach_2targets_single_array_v2 (line 224) plotResponse(hrdresp,xr,30);
Any suggestions ?
Regards, Philip
Honglei Chen
Honglei Chen 2015-2-11
Hi Philip,
Your H is a RangeDopplerResponse, which does not have knowledge of elevation angle, so it does not support this syntax. I thought you mean AngleDopplerResponse, which is elevation dependent. May I ask what you are trying to achieve with RangeDopplerResponse here? Thanks.

请先登录，再进行评论。

类别

在 帮助中心 和 File Exchange 中查找有关 Detection 的更多信息

产品

标签

提问:

Philip
Philip
2015-2-10

评论：

Honglei Chen
Honglei Chen
2015-2-11

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by