Is it possible to create a simscape block with three nodes?

1 次查看（过去 30 天）
Joel
Joel 2015-2-12
回答： David John 2022-11-21
Hello everyone, I am trying to implement a water filtration treatment unit with one flow going in (a:feed flow) and two flows going out (b:permeate and c:retentate flow).
How should the Branches section look like?
So far I tried:
branches
q_feed: a.q -> *;
q_permeate: * -> b.q;
q_retentate: * -> c.q;
end
Personally, I do not think that this declaration is right, since I get an error concerning 'transient initialization, solving for consistent states and modes, failed to converge'.
Thank you for your help. Joel
  2 个评论
Steven
Steven 2017-2-9
From what I understand * means ground or zero, so basically you are saying you want all those flows to be with respect to zero. Maybe this might work
q_permeate = a.q -> b.q;
q_retentate = a.q -> c.q;
that just tells the compiler what ports flow to what, then in the equations section you could put
a.q = b.q - c.q;
or whatever, I'm putting this as a comment because I'm not sure if its right
Ekin
Ekin 2022-10-17
编辑：Ekin 2022-10-17
Did you find any solution? equations section doesn't allow "a.q == b.q - c.q".

请先登录，再进行评论。

请先登录，再回答此问题。

采纳的回答

David John
David John 2022-11-21
branches
q1 : a.q -> b.q;
q2 : a.q -> c.q
end

更多回答（0 个）

类别

在 Help Center 和 File Exchange 中查找有关 Troubleshooting 的更多信息

标签

产品

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by