Suggetsed improvements list in SimBiology

1 次查看（过去 30 天）
emjey
emjey 2022-8-17
评论： Florian Augustin 2022-8-19
hi SimBiology team, here a list of things I recenlty found in SimBiology not working or worth improving - roughly in the order of importance.
  1. Check that the reaction rate's units are dimensionally consistent with units of the relevant species (see units issue).
  2. Parameters/species etc. cannot be alphabetically sorted (in Browser > Model > …) (also no sorting wrt other columns is possible).
  3. Plots disappear after collapsing – not always but often enough – and cannot be restored. The only solution is to restart SimBiology.
  4. Dropdown menus with plot settings keep disappearing as well – restarting toolbox only remedy.
  5. Validation shows errors if ‘unused’ parameters (listed in 'Model Tools / Unused' tab) have no units assigned, seems uncessary to me.
  6. Resizing of diagram with mouse wheel is impossible but would be very useful – could be done with e.g. ‘CTRL + mouse-wheel’.
  7. Adding breakpoints to edges.
Hope it helps. Best, Maciej

请先登录，再回答此问题。

回答（1 个）

Cris LaPierre
Cris LaPierre 2022-8-18
The best place to share your suggestions with MathWorks is here (Create Service Request then select the appropriate option):
https://www.mathworks.com/support/contact_us.html
  5 个评论
显示 3更早的评论
emjey
emjey 2022-8-19
编辑：emjey 2022-8-19
Yes, I was talking about plot in SimBiology Model Builder app / Model Simulation panel.
For example, consider the following:
  1. I create three plots. I run simulation, all plots are produced. So far so good
  2. I collapse plots 2 & 3 by clcking their lables, e.g. 'PLOT 2'.
  3. Then when I delete plot 1 via the 'Remove Plot...' option and all three plots disapear. Restarting SimBiology seems the only option to restore the plots.
I was able to reproduce that multiple times. Each time I was restarting SimBiology. It looks like a bug to me.
Florian Augustin
Florian Augustin 2022-8-19
Hi Maciej,
Thank you for the reproduction steps! I was able reproduce the issue using your example. This looks like a bug to me as well. We are working on fixing this.
Best regards,
Florian

请先登录，再进行评论。

社区

更多回答在  SimBiology Community

类别

在 Help Center 和 File Exchange 中查找有关 Extend Modeling Environment 的更多信息

标签

产品


版本

R2022a

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by