Problems using Data Acquisition Toolbox and MCC USB-1208FS data acquisition board with Matlab 2011a (64bits) in a PC with Windows 7 (64 bits).

5 次查看（过去 30 天）
Mercedes
Mercedes 2011-10-10
I'm programming a MCC USB-1208FS data acquisition board with Matlab 2011a (64bits) in a PC with Windows 7 (64 bits). Data Acquisition Toolbox supports the use of two interfaces. The legacy interface and the session-based interface. The session-based interface only works with National Instruments CompactDAQ devices. The legacy interface works with all supported data acquisition hardware but I cannot use the legacy interface on a 64–bit Windows system. What must I do? Must I use another version of Matlab, for example Matlab 2010 (32 bits) in my PC (64bits)? Must I change to another 32 bits PC?
Thank you very much for your kind attention.
Mercedes Granda

请先登录，再回答此问题。

回答（1 个）

Walter Roberson
Walter Roberson 2011-10-10
R2011b apparently has significantly more support for other devices... but be sure to check the documentation before buying.
For now: Yes, install the 32 bit version of MATLAB and use that.

类别

在 Help Center 和 File Exchange 中查找有关 Data Acquisition Toolbox Supported Hardware 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by