understanding how resp in phased.Cus​tomAntenna​Element works

1 次查看(过去 30 天)
I am tyring to understand the output from resp in the phased.CustomAntennaElement toolbox
The code is as follows:
myant= phased.CustomAntennaElement('AzimuthAngles',az, ...
'ElevationAngles',el,'RadiationPattern',pat_azel);
az, el is -90:90 and -180:180, pat_azel is the custom pattern 181x361
ang = [0 180];
resp = step(myant,fc,ang) gives 2 numbers ?
From the documentation thus far, ang is the value at az=0 elevation=180
so resp should only have a single value, I check the orginal output and it
is in dB mag. and not a vector. I followed this from the custom antenna element example.
Any feedback is welcome, thanks.
Regards, Philip

采纳的回答

Honglei Chen
Honglei Chen 2015-2-23
Hi Philip,
When you pass in ang = [0 180], it is considered as two angles, az = 0 and az = 180. if you pass in ang = [0;180], then it is one angle pointing at az = 0 and el = 180.
HTH

更多回答(0 个)

类别

Help CenterFile Exchange 中查找有关 Antennas, Microphones, and Sonar Transducers 的更多信息

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by