Error while using byte unpacking in simulink
显示 更早的评论
I have a basic simulink model with the objective of transferring a simple sine wave using udp send and receive blocks. Both the blocks are in the same model. I have used byte packing and unpacking for this model. After I run this, I am getting this error:
"slrealtimebytepacking(Unpack): Invalid inherited input port width 512 for data type 0 (1)"
what should I do to rectify this error ?
采纳的回答
Pavan Singh
2022-9-12
0 个投票
Make sure the UDP Receive and Send port width are set up correctly.
For example, if you are packing 1 "double" datatype signal,then the width should be 8 bytes. Also, if you're packing 2 "double" datatype signals, the width should be 16 because a double is 8 bytes (hence, total width/size is 2x8 = 16 bytes).
更多回答（0 个）
类别
在 帮助中心 和 File Exchange 中查找有关 Simulink Supported Hardware 的更多信息
2022-9-9
2022-9-12
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!
Translated by 
