Error while using byte unpacking in simulink

22 次查看（过去 30 天）
Nithesh Thakku Krishnamoorthy Ganesan
评论： Nithesh Thakku Krishnamoorthy Ganesan 2022-9-12
I have a basic simulink model with the objective of transferring a simple sine wave using udp send and receive blocks. Both the blocks are in the same model. I have used byte packing and unpacking for this model. After I run this, I am getting this error:
"slrealtimebytepacking(Unpack): Invalid inherited input port width 512 for data type 0 (1)"
what should I do to rectify this error ?

请先登录，再回答此问题。

采纳的回答

Pavan Singh
Pavan Singh 2022-9-12
Make sure the UDP Receive and Send port width are set up correctly.
For example, if you are packing 1 "double" datatype signal,then the width should be 8 bytes. Also, if you're packing 2 "double" datatype signals, the width should be 16 because a double is 8 bytes (hence, total width/size is 2x8 = 16 bytes).

更多回答（0 个）

类别

在 Help Center 和 File Exchange 中查找有关 Modeling 的更多信息

标签

产品


版本

R2022a

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by