improve for loop performance

Question

0 个投票

Hi,

I have a for loop runing on all values and takes into acount previous value

for i=2:length(a)
    a(i)=some_function(input1, input2, a(i-1))
end

where a is of size 200,000-300,000

Is there a way to improve it and speed up matlab performance?

0 个评论
显示 -2更早的评论隐藏 -2更早的评论

Answer 1

Walter Roberson 2022-9-20

0 个投票

In general:

you could get higher performance by moving the loop inside of some_function, so as to reduce the number of function calls
otherwise, it depends what is being calculated inside the function. The kind of code you are using is similar to what would be used to "filter" a signal, and if you can rewrite to use filt() or filtfilt() then that might be faster -- if the processing can be written in terms of derivatives or in terms of examining previous time steps. Also, if the computation is in terms of derivatives or timesteps, then Control System Toolbox transfer functions or state space models are sometimes good representations.
But there are certainly some computations that filter() and transfer functions are irrelevant for. There just might not be any useful speed improvement (other than running the calculation inside of one function to save on the function calls.)

Walter Roberson 2022-9-20

It sounds like input1 and input2 are not constants then?

michael 2022-9-20

Right They are the input values for current point for the hysteresis (x,y)