Continuous Wave Source Mismatch with Scope Output
显示 更早的评论
I am using the RF Blockset in MATLAB R2021a to access the Continuous Wave Source block with the output power set to 10 mW. I connect this to an "Outport" sensor set to an output in 'Magnitude and Angle Baseband'. However, when I read the sensor data to a scope, it displays as 100 mW.
采纳的回答
MathWorks Support Team
2022-9-8
0 个投票
The "Outport" block output is a power wave with units V/sqrt(ohm) or sqrt(watt). This is true when the output is 'Complex baseband', 'In-Phase and Quadrature Baseband', or 'Magnitude and Angle Baseband' . Thus, the power is (Mag)^2. If you add a "Square" block following the 'Mag' output, you will get the desired output reading.
更多回答（0 个）
类别
在 帮助中心 和 File Exchange 中查找有关 Get Started with RF Blockset 的更多信息
2022-9-8
2022-10-7
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!
Translated by 
