how do i make this pv model work
显示 更早的评论
I am trying to simulate a pv cell but the current controlled source block is giving the error "The 'CCS' block cannot be left open-circuit because it is modeled as a current source. You should try to resolve the open-circuit topology or delete this block from your model." How do I resolve this and make the circuit work.
1 个评论
Joe Jones
2023-9-21
I have the same error. Can you tell me the solution to this error?Thank you very much.
回答（3 个）
A Jenkins
2015-3-12
0 个投票
Close the circuit. You say you have a source of current, so where does that current go? Perhaps a resistor as a load?
anbumani p
2023-1-22
0 个投票
The 'Controlled Current Source' block cannot be left open-circuit because it is modeled as a current source. You should try to resolve the open-circuit topology or delete this block from your model.
Xing
2023-7-24
0 个投票
I have the same question. Even I give a constant value by Simulink block and connect the controlled current source block and also the two electrical ports are already connected. I got the same error.
类别
在 帮助中心 和 File Exchange 中查找有关 Simscape Electrical 的更多信息
2015-3-12
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!
Translated by 
