how do i make this pv model work

3 次查看（过去 30 天）
Olufemi Olayiwola
Olufemi Olayiwola 2015-3-12
评论： Joe Jones 2023-9-21
I am trying to simulate a pv cell but the current controlled source block is giving the error "The 'CCS' block cannot be left open-circuit because it is modeled as a current source. You should try to resolve the open-circuit topology or delete this block from your model." How do I resolve this and make the circuit work.
  1 个评论
Joe Jones
Joe Jones 2023-9-21
I have the same error. Can you tell me the solution to this error?Thank you very much.

请先登录，再进行评论。

请先登录，再回答此问题。

回答（3 个）

A Jenkins
A Jenkins 2015-3-12
Close the circuit. You say you have a source of current, so where does that current go? Perhaps a resistor as a load?
anbumani p
anbumani p 2023-1-22
The 'Controlled Current Source' block cannot be left open-circuit because it is modeled as a current source. You should try to resolve the open-circuit topology or delete this block from your model.
Xing
Xing 2023-7-24
I have the same question. Even I give a constant value by Simulink block and connect the controlled current source block and also the two electrical ports are already connected. I got the same error.

类别

在 Help Center 和 File Exchange 中查找有关 Sources 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by