how do i make this pv model work
12 次查看(过去 30 天)
显示 更早的评论
I am trying to simulate a pv cell but the current controlled source block is giving the error "The 'CCS' block cannot be left open-circuit because it is modeled as a current source. You should try to resolve the open-circuit topology or delete this block from your model." How do I resolve this and make the circuit work.
1 个评论
Joe Jones
2023-9-21
I have the same error. Can you tell me the solution to this error?Thank you very much.
回答(3 个)
A Jenkins
2015-3-12
Close the circuit. You say you have a source of current, so where does that current go? Perhaps a resistor as a load?
0 个评论
anbumani p
2023-1-22
The 'Controlled Current Source' block cannot be left open-circuit because it is modeled as a current source. You should try to resolve the open-circuit topology or delete this block from your model.
Xing
2023-7-24
I have the same question. Even I give a constant value by Simulink block and connect the controlled current source block and also the two electrical ports are already connected. I got the same error.
0 个评论
另请参阅
类别
在 Help Center 和 File Exchange 中查找有关 Schedule Model Components 的更多信息
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!