Designing Butterworth analog lowpass filter design for high frequencies.

Question

Sachin Trankatwar 2022-10-17

0
链接

此问题的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/1829068-designing-butterworth-analog-lowpass-filter-design-for-high-frequencies

回答： Nadia Shaik 2022-11-23

MATLAB code using built-in filter commands is given below for Butterworth analog lowpass filter design. The filter was designed for the following specifications: Passband frequency (fp) =30 Hz, Stopband frequency (fs) =60 Hz, Maximum passband attenuation (rp) = 1dB, and Minimum stopband attenuation (rs) = 40dB.

clc; clear all; close all;

% Given specifications

wp=2*pi*1000;

ws=2*pi*5000;

rp=1;

rs=40;

% code for order(n), cut-off frequency (wn), zeros (z), poles (p), gain (k)

[n,wn]=buttord(wp,ws,rp,rs,'s');

[z,p,k] = buttap(n);

% code for obtaining the filter transfer function coefficients

[b,a] = butter(n,wn,'low','s');

% code for plotting pole-zero plot

z1=tf(b,a);

figure(1)

pzmap(z1)

title('Butterworth Lowpass filter')

% code for obtaining magnitude values (h) at different frequencies (w) using filter coefficients (b,a) and plotting the frequency response

[h,w] = freqs(b,a);

figure(2)

plot(w,mag2db(abs(h)))

grid on;

title('Butterworth Lowpass filter');

ylabel('Gain in db');

xlabel('Frequency');

When I verify wp, ws, and wn in the simulation result, it matches the given specifications. However, when I change the wp and ws of a given specification to a high frequency (say, wp = 6280 and ws = 31400), ws and wn in the simulation result match the given specification, but wp does not. Could you please explain why?

0 个评论
显示 -2更早的评论隐藏 -2更早的评论

请先登录，再进行评论。

请先登录，再回答此问题。

Answer 1

Nadia Shaik 2022-11-23

0
链接

此回答的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/1829068-designing-butterworth-analog-lowpass-filter-design-for-high-frequencies#answer_1109183

Hi Sachin,

I understand that you want to design a Butterworth Lowpass filter with different 'passband corner frequency(Wp)' and 'stopband corner frequency(Ws)'. The input arguments of the function 'butterord', 'Wp' and 'Ws' are expected to be between 0 and 1, where 1 corresponds to the normalized Nyquist frequency, π rad/sample.

For more information, you may refer to the 'Input Arguments' section in the 'butterord' function documentation page.

I hope this helps.