UAV Toolbox Support Package for PX4 Autopilots-finish upload firmware

13 次查看(过去 30 天)
When I followed the normal steps to burn the flight controller firmware of v1.10.2 to pixhawk 2.4.8 (2mb flash memory), I was able to get the acceleration correctly, but when the burned PX4 connected to QGC, the firmware version was not recognized, and the led light on the PIXHAWK was abnormal (the BE light at IO was always on), I wanted to know if this is normal

回答(1 个)

Arun Mathamkode
Arun Mathamkode 2022-11-4
You can refer to the PX4 documentation to understand these status LED's and their meaning.





Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by