How to create meshgrid for unequal metrix.
14 次查看(过去 30 天)
显示 更早的评论
I am trying to plot pressure contour for roof (40'X125') where 8 main tap lines are given and another 7 sub tap lines starts after 99'; hence, tributary dimensions in 1 direction is reduced after 99'. Therefore, how to create meshgrid in this case. Image is given here for the reference.
0 个评论
采纳的回答
William Rose
2022-11-3
The answer below shows how to create a grid that is non-uniform. The figures in the answer show how it worked.
However, the answer above does not reproduce a pattern like the one in your figure. meshgrid() cannot make a mesh like the one in your figure, because your figure has different numbers of rows for different columns.
I do not understand exactly what you are trying to do with the diagram shown. Do you have measurements at the dots shown on the diagram, and you want to make a contour plot using the measured values?
.
5 个评论
更多回答(0 个)
另请参阅
类别
在 Help Center 和 File Exchange 中查找有关 Contour Plots 的更多信息
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!