add ylim and xlim only in the magnitude response of bode plot?

95 次查看（过去 30 天）
SimTec
SimTec 2022-11-22
评论： Ben 2024-3-25
hi guys,
How to add the ylim and xlim to the bode plot, magnitude only?
I havre added the ylim and xlim but the lines shows up in the phase plot and not the magnitude plot!
Cheers

请先登录，再回答此问题。

回答（1 个）

Robert U
Robert U 2022-11-22
Hi SimTec,
If you are using bodeplot, you can have a look at bodeoptions()-command. There you can set the axis limits.
Kind regards,
Robert
  2 个评论
Ben
Ben 2024-3-25
I have this issue as well. XLim is fine, I want them to be the same for both the magnitude and phase plots, but the YLIM applies the same limits to the phase and magnitude plots! There does not seem to be in bodeoptions a way to distinguish between the two plots.
Ben
Ben 2024-3-25
So the answer is simple... you add them in a cell like so:
opts.YLim = {[-20 10],[-50 150]}

请先登录，再进行评论。

类别

在 Help Center 和 File Exchange 中查找有关 Get Started with Control System Toolbox 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by