add ylim and xlim only in the magnitude response of bode plot?
57 次查看(过去 30 天)
显示 更早的评论
hi guys,
How to add the ylim and xlim to the bode plot, magnitude only?
I havre added the ylim and xlim but the lines shows up in the phase plot and not the magnitude plot!
Cheers
0 个评论
回答(1 个)
Robert U
2022-11-22
Hi SimTec,
If you are using bodeplot, you can have a look at bodeoptions()-command. There you can set the axis limits.
Kind regards,
Robert
2 个评论
Ben
2024-3-25
I have this issue as well. XLim is fine, I want them to be the same for both the magnitude and phase plots, but the YLIM applies the same limits to the phase and magnitude plots! There does not seem to be in bodeoptions a way to distinguish between the two plots.
Ben
2024-3-25
So the answer is simple... you add them in a cell like so:
opts.YLim = {[-20 10],[-50 150]}
另请参阅
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!