using less than operator and combination of if and for statement

Question

Walaa 2022-12-3

0
链接

此问题的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/1870367-using-less-than-operator-and-combination-of-if-and-for-statement

回答： Walter Roberson 2022-12-3

I'm trying to use the less than operator and getting the following error (for vertical Height 102 Error: Invalid operator use). also Is the for and if statement combination I'm using correct?

%calculate Rim to disc ratio
shortestRimLength=minDistance;
DiameterOfDisc=verticalHeight
%Rim to disk ratio estimation
RDR=shortestRimLength./DiameterOfDisc;
for DiameterOfDisc<102
if RDR>0.4
    disp('NORMAL')
    msgbox('NORMAL')
elseif RDR <0.2 && RDR>=0.4
    disp('EARLY GLAUCOMA ')
    msgbox('EARLY GLAUCOMA ')
else RDR<=0.2; 
    disp(' ADVANCED GLAUCOMA ')
    msgbox(' ADVANCED GLAUCOMA ')
end

0 个评论
显示 -2更早的评论隐藏 -2更早的评论

请先登录，再进行评论。

请先登录，再回答此问题。

Answer 1

Walter Roberson 2022-12-3

0
链接

此回答的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/1870367-using-less-than-operator-and-combination-of-if-and-for-statement#answer_1119417

在 MATLAB Online 中打开

You cannot use a condition in for : if you need to use a condition you should be using while

Note that when you use while, at least one of the variables involved in the test needs to be changing inside the loop, or else you will end up with an infinite loop (unless you do have something changing and you use break)

Your RDR is not changing inside the loop, so if you entered the loop at all, you would never exit the loop.

I have to wonder if what you want is instead

if DiameterOfDisc < 102

rather than a loop at that point.