Simulink Logic - Capturing a Signal Value at a Specific Point for Control

25 次查看（过去 30 天）
PB75
PB75 2022-12-7
评论： PB75 2022-12-13
Hi,
I am creating a controls model in Simulink and need to capture a simulink signal at a specific point in the simulation, and then keep the value to use as an input to the controller for the next cycle. I can capture the signal value from the point of interest (velocity = 0) to the end of the simulation, but I would like to lock that value at the trigger point and then reset at the next. I have added a screen grab to show the blocks I am using, and the output.
The value I need to capture is the position when the velocity reaches 0, so when the position changes direction.
Its a basic logic question, but any help would be great,
Cheers
Patrick

请先登录，再回答此问题。

采纳的回答

PB75
PB75 2022-12-7
Hi Fangjun,
As in the following? Using a DataStoreMemory block in the triggered subsystem?
  2 个评论
Fangjun Jiang
Fangjun Jiang 2022-12-7
Put the DataStoreMemory block outside. Inside, import the position signal, feed it to a DataStoreWrite block.
PB75
PB75 2022-12-13
Thanks Fangjun.
I have removed the DataStoreWrite block as the triggered subsystem captures the signal at that point.

请先登录，再进行评论。

更多回答（1 个）

Fangjun Jiang
Fangjun Jiang 2022-12-7
The logic of velocity >=0 will generate a step output signal. Use this signal to trig a triggered subsystem. Specify the trigger as rising edge. Inside, use Memory Write block to store the value.

类别

在 Help Center 和 File Exchange 中查找有关 Modeling 的更多信息

标签

产品


版本

R2022a

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by